Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateRheem AC Installation in New York: What to Know First
A full Rheem AC installation in New York typically runs $4,130 to $8,850, depending on the model line, your home’s square footage, and how much of the existing ductwork and electrical is still worth keeping. We’re an independent Rheem service provider, not a factory store, so our job is to tell you which Rheem system actually fits your apartment or house and why, before anyone touches a tool. Most installations are scheduled and completed within three to five business days once we’ve confirmed the equipment and the scope.
This page is for New York homeowners and building owners who already have a Rheem, are considering one, or just want a straight answer about what a Rheem install costs and what it involves. Call (934) 465-5501 and you’ll get a live person, not a voicemail tree. We’ll answer your questions and set a firm arrival window.
How Rheem Products Fail – and How We Fix Them
Rheem builds solid equipment, but every brand has patterns. Here’s what we see on Rheem systems in New York homes, and how we address it during an installation or before one is needed.
- Rheem Classic Series (RA13/RA14) evaporator coil leaks. These are the most common Rheem units in older New York homes. After seven to ten years, the thin aluminum fins on the indoor coil can develop pinhole leaks, especially in buildings where the air runs salty or humid off the rivers. We don’t patch coils. If a coil is leaking, we replace it with an OEM Rheem coil so the warranty stays intact, and we check the refrigerant charge before recommending a full system swap.
- Rheem Prestige Series (RA17/RA20) inverter board faults. The higher-efficiency Prestige line uses a variable-speed compressor controlled by an inverter board. When that board fails, the symptom is usually a system that short-cycles or won’t ramp up on the hottest afternoons. Board failure is often caused by voltage fluctuations, which older New York apartment buildings deliver plenty of. We verify line voltage before replacing the board, because putting a new board on a dirty power feed just means another failure in a year.
- Rheem Achieve Series (RA15) outdoor fan motor bearing wear. The Achieve line is a workhorse, but after several years the outdoor condenser fan motor bearings can get loud. New York homeowners notice it as a hum or rattle from the condenser cage. We don’t just swap in a generic aftermarket motor. We check the fan blade balance and capacitor first, because a weak capacitor will kill a new motor the same way it killed the old one.
- Rheem communicating thermostat compatibility gaps. Rheem’s communicating system (the EcoNet-enabled models) only talks properly to Rheem’s own EcoNet thermostat or an approved integration. We see installers put a Nest or Ecobee on a communicating Rheem and the system loses its variable-speed logic, which defeats the reason you paid for a high-efficiency unit. On installation day we confirm which thermostat actually controls the system correctly before we leave.
- Rheem drain pan rust on horizontal attic installs. In New York homes where a Rheem air handler sits horizontally in an attic or crawl space, the secondary drain pan is often a place where condensation collects and rusts through. We replace rusted pans with OEM Rheem pans and, more importantly, check the drain line pitch so the next pan doesn’t sit in standing water.
Styles & brands we work with
Our Rheem AC Installation Process
Here’s exactly how a Rheem installation goes when you call Cold Harbour Heating and Air New York.
- 1
You call (934) 465-5501. A live person answers. We get your address, the age and model of your current Rheem if you have one, and the symptom or goal. We set a firm arrival window, not a four-hour maybe.
- 2
Victor or one of the crew walks the job. We look at the existing condenser, the indoor coil, the ductwork, the electrical panel, and the thermostat. We take measurements, check static pressure, and look at how much space exists for the new unit. Nothing gets quoted until this walk is done.
- 3
You get a written price. The price covers the equipment, the labor, the refrigerant, the electrical work, and the haul-away of the old unit. It is hand delivered before any work starts. It does not change at the door.
- 4
Installation day. We arrive in the window we gave you, in uniform, with background-checked technicians. We remove the old Rheem or competitor unit, set the new one, connect the lines, wire the electrical, and commission the system. We run it through a full startup sequence and log the refrigerant pressures and temperature split.
- 5
Cleanup and walkthrough. We leave the job site cleaner than we found it. We show you the new system, explain the thermostat, and hand you the paperwork: your written guarantee, your warranty registration, and the startup report.
- 6
365-Day Done Right Promise. If anything we touched fails within a year, you call us and we come back at no charge. That’s in writing on every installation we do in New York.
What Rheem AC Installation Costs in New York
Here are real numbers for common Rheem installation scenarios in New York.
- Rheem Classic 13-14 SEER, 2-3 ton: $4,130 – $5,600. A straightforward replacement using existing ductwork and a standard thermostat.
- Rheem Achieve 15-16 SEER, 3-4 ton: $5,200 – $7,100. The most common choice for larger New York apartments and single-family homes.
- Rheem Prestige 17-20 SEER with EcoNet: $6,800 – $8,850. Variable-speed comfort, better humidity control, and the highest efficiency Rheem’s residential line offers.
What moves the price: whether we’re replacing an existing system or installing central air from scratch, the condition of your ductwork, whether you need a line-set replacement, and whether your electrical panel has room for a new circuit. On a replacement job, we reuse what’s still good and tell you plainly what isn’t. On a first-time install, we give you a written scope that covers everything from the pad to the thermostat. Call (934) 465-5501 for a free estimate. You’ll get the number before we start, not after.
See the difference
Before
After
Before
After
Before
AfterWhy New York Homeowners Call Cold Harbour Heating and Air New York for Rheem Work
We’ve been doing this since 2003, and we run every job the Kingswell Way: say the price before the work, show up in the window given, leave the place cleaner than found, put the guarantee in writing, and come back if it fails. That’s not a slogan here. It’s a set of rules we don’t bend.
Victor Mancini learned the trade at Los Angeles Trade-Technical College before moving his work east. When he’s on a Rheem job in New York, he can tell you what the system is doing and what it needs without guesswork, which is exactly what a homeowner deserves. We’re trained on nine major HVAC brands, so if you have a Carrier, Trane, or Lennox in another part of the building, the same crew can handle it.
And the name: a cold harbour was a roadside shelter where travelers waited out the weather. Comfort in any season is the job. That’s what we do in New York year-round.
FAQs
Yes. As an independent Rheem service provider, we install and service Rheem equipment every week across New York. We source OEM Rheem parts when warranties require it, and we register your equipment with Rheem so the manufacturer’s warranty is in your name from day one. What we bring to the table is the installation workmanship and the written 365-Day Done Right Promise, which sits on top of Rheem’s factory coverage.
Most standard replacements take one full day. First-time central air installs, where we’re adding ductwork, a new electrical circuit, and a pad, can run two to three days depending on the building. We’ll give you a timeline in writing before the work starts and we stick to it.
If your Rheem is under ten years old and the failure is a single component like a capacitor or a contactor, repair usually makes sense. If the compressor has failed or the coil is leaking and the unit is over twelve years old, the math usually favors replacement. We’ll show you the repair cost in writing and the replacement cost in writing, and let you decide without pressure. Call (934) 465-5501 and we’ll give you both numbers before you choose.
Yes. Rheem builds some of the better cold-climate heat pumps on the market, and many New York homes are good candidates. A heat pump gives you heating and cooling from the same outdoor unit, which can drop your winter gas bill. We’ll do a load calculation before recommending a heat pump, because the wrong size heat pump is worse than the right size AC.
Rheem’s factory warranty typically covers the compressor and heat exchanger for ten years, with parts coverage that varies by model and registration. On top of that, our installation is covered by the 365-Day Done Right Promise. If anything we installed fails within a year, we come back and correct it at no charge. That’s in writing, not verbal.
In most cases, yes. We keep same-day and next-day slots for cooling failures during the summer months in New York, because a failed AC in a heat wave is a health risk, not an inconvenience. Call (934) 465-5501 and a live person will tell you the soonest real window we have.
Get Your Rheem AC Installation Quote
If you’re in New York and need a Rheem AC installed, replaced, or evaluated, call us at (934) 465-5501. Tell us what the system is doing, and Victor or one of the team will tell you what it needs, no guesswork, no surprises. The estimate is free, the price is written before we start, and the work is guaranteed in writing for a full year.
Written by Victor Mancini, Owner, Cold Harbour Heating and Air New York at Cold Harbour Heating and Air New York, serving New York and nearby areas.